Peakworks compliance polyester safety harness, class A, one D-ring and pass-thru buckles , one size fit all

Peakworks class A compliance safety harness with back D-ring. This harness consists of 3 adjustment points; 2 at the legs and 1 at the chest. In addition, it is designed with a sub-pelvic support strap. The straps of the chest and thighs are joined by pass-thru buckles. This harness is offered in one size fit all. This harness can support a maximum weight of 400 lb (180 kg), including clothing, tools, etc. This basic harness is chosen for occasional construction or maintenance work.

Peakworks product code: V8001000 or model FBH-10002A
Complies with CSA Z259.10-06 and AINSI Z359.11

The Peakworks Safety Harness is made with high visibility green polyester straps. The straps of the chest and thighs are joined by pass-thru buckles. Polyester offers a superior resistance to acids. The economic side of this harness is reflected in the appearance of its metal components compared to the models: Contractors or Peakpro.

Inspection:

The product identification and certification labels are sewn onto the strap on the back left side of the safety harness. The worker is responsible for visually inspecting the harness before each use. During this routine inspection, the worker must note any signs of degradation, malfunction, or breakage. The harness will have to be replaced if any such signs are detected.

On top of this routine inspection, the harness must be inspected by a qualified person different than the worker that wears the harness. The frequency of these inspections varies according to the manufacturer. Some manufacturers require an inspection every 90 days, others every 180 days, or even yearly. These inspections should be performed more often if the harness is worn in extreme environmental working conditions.

The recommended lifetime of a safety harness if 5 years. While some manufacturers keep silent on this topic, in practice, if the harness is used regularly and stored and maintained in standard conditions, its lifetime will not exceed 5 years in most cases. Sylprotec offers a safety harness inspection service. Find out more by clicking on the Services tab, under the Sylprotec logo at the top of the page. Any equipment that has withstood a fall or an impact must be scrapped.

Maintenance:

For cleaning, use a gentle soap or detergent and lukewarm water (37°C). Do not use bleach, chlorine, or other abrasive or chemical products. If your harness is too dirty or contaminated, it is time to replace it. Air dry without using heat, in a clean environment. You can accelerate the drying process by wiping the wet harness with a clean absorbent wipe, or by using a fan. Avoid exposing the harness to sunlight and to any sources of contamination.

Suggestion:

To complete your fall protection you will find a range of lanyards, retractable and anchors. Some products are suggested under the "accessories" tab at the bottom of this page.

Other equipment frequently used with this safety harness:

Safety glasses YA12E93101DX
Liberty TA14LR safety helmet and the essential TA14CS chin strap
EPTCONE28 Traffic Cones
Peakworks FPBAG storage bag
The FPL9900 Tool Strap

The texts coloured in green correspond to hyperlinks leading to specific safety equipment or to a general information link.